Technological advantage PK
Similar products
Traditional Pipe in Pipe
1: The damage must be integrated with the lamp or ballast exchange, high cost and after-sales service difficult.
2: Traditional line technology bottlenecks, do not touch the lamp with the board two vehicles, will immediately lead to burn out the ballast, the traditional need to replace the entire increase replacement costs, the customer is difficult to accept.
3: Traditional lines, more components, more space, and to do at the end of the rectifier, cooling is very good, serious impact on product quality and service life.
4: The traditional tube lamp tube with non-standard, general agents and end users can not be purchased in the market, service is almost totally dependent on manufacturers, logistics and freight forwarding time can not afford to let your customers, etc..
5: Traditional pipe tube plastic components used in the PP material, plastic head and fragile, not fire.
6: Traditional tube pipe with 0.8mm (or 1.0mm) of ordinary glass, fragile, light transmission rate is only about 90%.
7: Traditional Pipe in Pipe using ordinary T5 tubes, light efficiency is usually 80lm / w or so.
Light tube Light tube
1: Light ray tube in tube using the most advanced and most reasonable split of the structure, you can always replace the lamp or the ballast, after-sales service and low cost.
2: The Light of the Light Pipe in Pipe Lines with integrated circuits inside the integrated circuit, there are various protection features, including: short circuit, open circuit, lamp abnormalities, tube leakage, high voltage, low voltage, over current, less current. Effective protection can not be burned up lamps and ballasts.
3: Light tube Light tube with integrated circuits, and the relatively high temperature drying in the tube the other end of inductor not only reduces the ballast own temperature and the effective protection of other electronic components of the normal work environment, and the entire town of flow more reasonable arrangement of control circuits, which greatly reduces the work of rectifier circuit board space, to a greater extent to increase the length of the lamp's light.
4: Optical Light Pipe in Pipe directly to the national standard T5 lamp standard, widely available on the market to buy, and the price is much cheaper than non-tube, customers need a different color temperature lamp, ready to be according to their requirements need to be replaced.
5: The fire retardant high temperature resistant material ABS plastic parts, can be high temperature 200C degree, the use of more safe and reliable.
6: borosilicate glass tube with 1.67mm (commonly known as: Ex tube) looks more beautiful, light transmission rate of 95% or more.
7: Optical Light Pipe in Pipe T5 fluorescent lamps really three primary colors of light than the efficiency of 88lm/w-95lm/w, higher brightness.
Categoría de noticias
